Installs in Johnstown
Strata Heat Pumps installs heat pumps in Johnstown, in every ZIP code listed on this page. The online estimate gives a price range and your rebates for a Johnstown address in about two minutes.
Johnstown homes are newer than Weld County homes
Census figures count 6,647 homes in Johnstown, with 6,594 occupied. The median home was built in 2007 and has 6.3 rooms. Weld County has 125,033 homes, a 2000 median build year, and 6.2 median rooms. Johnstown's housing stock is newer, so many homes start with newer ducts and layouts than the county as a whole.
Homes built in 2010 or later make up 39% of Johnstown, compared with 24% across Weld County and 14% across Colorado. Only 6.3% of Johnstown homes were built before 1960, while Weld County has 12% and Colorado has 16.3%. This points toward ducted replacement and dual-fuel options for much of Johnstown's newer detached housing.
Johnstown has 79.8% detached houses, above Weld County's 73.1% and Colorado's 61.8%. Its 15% share in any multi-unit building is close to Weld County's 16%, but below Colorado's 26.9%. Owner occupancy is 77.3%, above 75.5% in the county. Homeowners can match the system to their existing ducts, floor plan, and long-term heating goals.
Johnstown compared with nearby towns
Johnstown's 2007 median build year sits near Berthoud's 2008, ahead of Milliken's 2004 and Mead's 2003, and well ahead of Gilcrest's 1975. Berthoud has 48.2% of homes built in 2010 or later. Johnstown has 39%, compared with 23% in Milliken, 21.4% in Mead, and 0% in Gilcrest. Newer homes usually call for a different load calculation than older nearby homes.
Gas heat serves 79% of Johnstown homes. That is lower than Berthoud's 81.5%, Milliken's 82.8%, and Mead's 90.8%, but above Gilcrest's 77.9%. Electric heat serves 18.2% in Johnstown, compared with 16.5% in Berthoud, 14.6% in Milliken, 6.5% in Mead, and 18.5% in Gilcrest. Existing fuel changes both system choices and available rebate totals.
Detached houses account for 79.8% in Johnstown, close to Berthoud's 79.2% and Gilcrest's 81.9%. Milliken reaches 85.6% and Mead reaches 90.8%. Johnstown's 15% share in any multi-unit building exceeds Berthoud's 9%, Milliken's 3.1%, Mead's 2.6%, and Gilcrest's 0%. Condos and smaller multi-unit homes need closer attention to equipment location and indoor-unit placement.
Heat pumps for Johnstown's housing stock
A ducted heat pump fits homes with usable central ducts. It moves heat rather than burning fuel, and it cools the home as well. This suits much of Johnstown's 79.8% detached-house stock, especially the 31.8% built from 2000 to 2009 and the 39% built in 2010 or later. We measure the home, inspect the ducts, and check the electrical panel before installation.
Dual fuel pairs a heat pump with the existing gas furnace. The heat pump handles normal heating, while the furnace remains for the coldest hours. That matches Johnstown's 79% utility-gas share and its newer homes with central forced-air equipment. It gives gas-heated households a path to heat-pump cooling and heating without removing the furnace.
Ductless systems fit homes without ducts, additions, and condos. They deserve attention in Johnstown because 15% of homes are in any multi-unit building, and 18.2% heat with electricity. Older homes are more likely to lack ducts or have small ducts. A ductless layout puts indoor units where heat and cooling are needed, rather than relying on a central duct system.
Sizing a Johnstown heat pump
Our estimate tool sizes equipment to an outdoor design temperature of 1°F and an indoor design temperature of 70°F. It uses an elevation of 5,300 ft. At that elevation, an air-source unit loses 18% of heat output. The design calculation accounts for that loss, instead of selecting equipment by floor area alone.
Consider the example home, a 2,000 square foot, 2-story gas-heated home built in 2010 or later. Its design heat load is 2.0 tons, and the estimate calls for a 20 A breaker. At the design temperature, the modeled heat pump delivers 2 units of heat for each unit of electricity. This is why Johnstown equipment needs a cold-climate design calculation.
The same 2,000 square foot, 2-story gas home needs a different size as its construction era changes. A home built from 2000 to 2009 has a 2.4 tons design load. A home built from 1980 to 1999 has a 2.8 tons load. One built before 1960 has a 3.4 tons load. Construction details and heat loss drive sizing, not an assumed equipment size.
For a 1,500 square foot ductless example, the estimate uses 3 indoor units. Its planning allowance is 500 sq ft of floor area per indoor unit. The online estimate prices up to 5 indoor units before a custom quote. We confirm room layout, electrical capacity, and the needed indoor-unit locations before work begins.
Johnstown heat pump prices and rebates
For the 2,000 square foot, 2-story gas example built in 2010 or later, a ducted heat pump is $12,800 to $21,300 before rebates and $7,300 to $15,800 after rebates. A dual-fuel system is $10,200 to $17,100 before rebates and $4,700 to $11,600 after rebates. The dual-fuel price reflects keeping the gas furnace for the coldest hours.
The 1,500 square foot ductless example has 3 indoor units. Its price is $11,800 to $19,200 before rebates and $8,300 to $15,700 after rebates. Ductless pricing follows the number of indoor units and the layout. A home that needs different coverage gets a custom plan after we inspect its rooms and electrical panel.
Gas-heated Johnstown homes can stack $7,000 for a 3-ton ducted heat pump. That total includes the Xcel Energy rebate ($4,500), the State of Colorado Heat Pump Discount ($1,000) and the Power Ahead Colorado rebate ($1,500). Homes now using electric heat have $4,700 in this same comparison, from the Xcel Energy rebate ($2,200), the State of Colorado Heat Pump Discount ($1,000) and the Power Ahead Colorado rebate ($1,500). The gas total is higher because the Xcel Energy rebate differs by the existing heating fuel.
The State of Colorado Heat Pump Discount applies to every Colorado home on any of the three systems, and it comes off the invoice. The Power Ahead Colorado rebate applies in Weld County on all three systems. Xcel Energy rebates apply to eligible Xcel Energy customers on all three systems, with separate paths for gas or propane homes and electric-heated homes. We file every rebate for the homeowner.
Johnstown ZIP code 80534
The supplied ZIP data identifies 80534 as the Johnstown ZIP profile. It contains 7,137 homes, has a 2006 median build year, and is close to the townwide 2007 median. The ZIP profile has 39.2% of homes built in 2010 or later, almost the same as Johnstown's 39%. Its 7.7% share built before 1960 is slightly above the townwide 6.3%.
Gas heat reaches 76.2% in 80534, below Johnstown's 79%. Electric heat is 19.3%, above the townwide 18.2%, while propane is 2.3%, above Johnstown's 0.9%. Those fuel shares matter because gas, propane, and electric homes have different rebate totals and may start with different heating equipment.
Detached houses make up 80.4% of 80534, close to Johnstown's 79.8%. Any multi-unit building represents 13.7%, below the townwide 15%. No second Johnstown ZIP profile appears in the supplied data, so there is no ZIP-to-ZIP housing comparison to make. We use the home's actual ducts, fuel, panel, and construction details to select the system.
Johnstown in numbers
| Homes | Median year built | Built before 1960 | Built 2010 or later | Gas heat | Electric heat | Propane | |
|---|---|---|---|---|---|---|---|
| Johnstown | 6,647 | 2007 | 6.3% | 39% | 79% | 18.2% | 0.9% |
| Weld County | 125,033 | 2000 | 12% | 24% | 73.9% | 17.1% | 6.7% |
| Colorado | 2,545,124 | 1987 | 16.3% | 14% | 66.7% | 25.2% | 4.9% |
| ZIP | Main town | Homes | Median year built | Heat with gas | Electric utility | Install area |
|---|---|---|---|---|---|---|
| 80534 | Johnstown | 7,137 | 2006 | 76.2% | Xcel Energy | Yes |
Systems and rebates in Weld County
- Ducted heat pump in Weld CountyPrices by home age and the Weld rebates for this system.
- Dual-fuel heat pump in Weld CountyPrices by home age and the Weld rebates for this system.
- Ductless mini-split in Weld CountyPrices by home age and the Weld rebates for this system.
- Heat pump rebates in Weld County$7,000 on a 3-ton gas home, program by program.
- Pool heat pumps in Weld CountyPool and spa heat pumps: local code rules, running cost and the swim season.
Other towns we install in
Questions we hear
What heat source do most Johnstown homes use?
Utility gas heats 79% of Johnstown homes. Electricity heats 18.2%, propane heats 0.9%, and solar heats 0.9%. A dual-fuel system suits many gas-heated homes because it retains the gas furnace for the coldest hours. Ductless equipment fits electric-heated homes, additions, condos, and homes without central ducts.
How are heat pumps sized in Johnstown?
We size to 1°F outdoors and 70°F indoors, using 5,300 ft for the elevation calculation. Air-source equipment loses 18% of output at that elevation. The 2,000 square foot, 2-story gas example built in 2010 or later has a 2.0 tons design load and a 20 A breaker requirement.
What rebates apply to a gas-heated Johnstown home?
A gas-heated home can receive $7,000 in the 3-ton ducted comparison. The stack is the Xcel Energy rebate ($4,500), the State of Colorado Heat Pump Discount ($1,000) and the Power Ahead Colorado rebate ($1,500). The State of Colorado Heat Pump Discount comes off the invoice. We file every rebate for the homeowner, and the Power Ahead Colorado rebate applies in Weld County on all three system types.
What does the example ducted or dual-fuel system cost?
For the 2,000 square foot, 2-story gas example built in 2010 or later, ducted pricing is $12,800 to $21,300 before rebates and $7,300 to $15,800 after rebates. Dual-fuel pricing is $10,200 to $17,100 before rebates and $4,700 to $11,600 after rebates. A winter gas bill makes the online estimate more accurate.
How long does a Johnstown heat pump installation take?
Most installations take one day. Jobs with several ductless indoor units can take two or three days. Before installation, we measure the home and check the ducts and electrical panel. We install Mitsubishi, Bosch, Daikin, Carrier, and Trane equipment, then match the system type to the home's heating setup and layout.