Installs in Frederick
Strata Heat Pumps installs heat pumps in Frederick, in every ZIP code listed on this page. The online estimate gives a price range and your rebates for a Frederick address in about two minutes.
Heat pumps for Frederick homes
Frederick has 5,584 homes across 15.208 square miles. Census figures put the median home year at 2007, compared with 2000 in Weld County and 1987 statewide. The town has 6.8 median rooms, above Weld County's 6.2 and Colorado's 5.7. These are substantial homes, so room count, duct layout, and the actual heating load deserve attention before choosing equipment.
Frederick's housing stock is newer than nearby Longmont, where the median home year is 1990. It matches Firestone and Erie at 2007, while Dacono's median is 2010. Homes built in 2010 or later make up 39.8% of Frederick, below Dacono's 49.9%, above Firestone's 36.9%, and close to Erie's 39.4%. A heat pump should be sized to the individual home, not its town's median year.
Detached houses account for 96.3% of Frederick homes. That exceeds Weld County's 73.1%, Colorado's 61.8%, Dacono's 74.3%, Firestone's 73.5%, Erie's 86.6%, and Longmont's 60.5%. Multiunit buildings account for 1.8%, compared with 16% across Weld County. Frederick's housing points strongly toward whole-home equipment for detached houses, while ductless systems suit the smaller attached and multiunit share.
How Frederick homes heat today
Utility gas heats 88.4% of Frederick homes. That is above Weld County's 73.9%, Colorado's 66.7%, Dacono's 79.7%, Firestone's 82.3%, Erie's 81.3%, and Longmont's 76.3%. Xcel Energy supplies gas here. For homes replacing a gas furnace, both a ducted heat pump and a dual-fuel system fit the dominant local starting point.
Electricity heats 10.8% of Frederick homes, below Weld County's 17.1% and Colorado's 25.2%. It is also below Dacono's 17.4%, Firestone's 15.2%, Erie's 16.8%, and Longmont's 21%. Ductless equipment is a direct fit for electric-heated homes without ducts. It also cools and works well in an addition or condo.
Propane heats 0.1% of Frederick homes, and wood heats 0.1%. Solar accounts for 0.6%, while fuel oil and other or no fuel each account for 0%. Gas remains the defining fuel choice here. A dual-fuel system retains the gas furnace for the coldest hours, while the heat pump handles heating and cooling through the rest of the year.
Three heat pump choices for Frederick
A ducted heat pump fits Frederick's many detached homes with usable ducts. The town's 2000 to 2009 homes account for 39.7%, and homes built in 2010 or later account for 39.8%. We measure the home, inspect the ducts, and check the electrical panel before installation. This identifies whether the existing duct system can deliver the airflow the selected heat pump needs.
Dual fuel fits gas-heated homes that want to keep a furnace for the coldest hours. Frederick has 5,454 occupied homes and an owner-occupied rate of 95.8%, above Weld County's 75.5% and Colorado's 66.3%. For an owner planning a whole-home replacement, dual fuel pairs the existing fuel pattern with heat pump heating and cooling.
Ductless mini-splits fit homes without ducts, additions, condos, and rooms that need separate conditioning. Frederick's attached houses account for 0.9%, and buildings with 2 to 9 units account for 1.5%. Buildings with 10 or more units account for 0.3%. The multiunit share is small, but these homes need a system choice based on room layout rather than a whole-house duct plan.
Sizing a Frederick heat pump
We size Frederick systems to 1°F outdoors and 70°F indoors. Our sizing uses an elevation of 5,300 ft, where an air-source unit loses 18% of heat output. At the design temperature, the equipment delivers 2 units of heat for each unit of electricity. Elevation and deep cold make a design-temperature calculation necessary, rather than a rule based on floor area alone.
Our example is a 2,000 square foot, 2-story gas-heated home built in 2010 or later. Our estimate tool assigns it a design load of 2.0 tons and a 20 A breaker. This home type reflects Frederick's largest construction groups, where 39.8% of homes were built in 2010 or later and 39.7% were built from 2000 to 2009.
Age still changes the load. A 2,000 square foot, 2-story gas home built before 1960 has a 3.4 tons design load, while the 2010 or later example has 2.0 tons. Only 3% of Frederick homes predate 1960, compared with 12% in Weld County and 16.3% statewide. Older homes are more likely to have no ducts or undersized ducts, so we inspect them before recommending ducted equipment.
Heat pump prices and rebates in Frederick
For the 2,000 square foot, 2-story gas example, a ducted heat pump costs $12,800 to $21,300 before rebates and $7,300 to $15,800 after rebates. A dual-fuel system costs $10,200 to $17,100 before rebates and $4,700 to $11,600 after rebates. Our estimate tool produces these ranges from the example home's design load, equipment type, and local rebate settings.
The gas-heated ducted example has total rebates of $7,000. That total includes the Xcel Energy rebate ($4,500), the State of Colorado Heat Pump Discount ($1,000) and the Power Ahead Colorado rebate ($1,500). The State of Colorado Heat Pump Discount is available for every Colorado home on each of the three systems, and it comes off the invoice. Power Ahead Colorado applies in Weld County on each system. We file every rebate for the homeowner.
For a home now using electric heat, the ducted total is $4,700, made up of the Xcel Energy rebate ($2,200), the State of Colorado Heat Pump Discount ($1,000) and the Power Ahead Colorado rebate ($1,500). A ductless mini-split replacing electric heat also has total rebates of $4,700. The gas-heated ductless total is $7,000. Rebate totals differ by the current heating fuel, so a gas furnace and electric heat should not be priced as if they receive the same programs.
The federal 25C credit ended for systems installed after 2025-12-31. Current local pricing should use the available rebate programs for the home's existing heat.
Frederick ZIP codes and installation planning
ZIP code 80530, whose main town is Frederick, has 2,315 homes and a median home year of 2005. Utility gas heats 85.2% there, compared with 82.3% in 80504 and 81.8% in 80516. Electricity heats 13.9% in 80530, versus 15% in 80504 and 15.9% in 80516. The fuel mix supports checking each home's existing furnace or electric system before choosing rebates.
The 80530 ZIP has 35.7% of homes built in 2010 or later. That is higher than 23.9% in 80504 and lower than 42.3% in 80516. Detached homes represent 92.7% in 80530, compared with 75.2% in 80504 and 86.4% in 80516. This ZIP has a stronger detached-house pattern, which favors a whole-home ducted or dual-fuel evaluation.
Multiunit buildings make up 2.7% of homes in 80530. That is below 14% in 80504 and 3.8% in 80516. Ductless equipment is especially relevant where a home lacks ducts, has an addition, or needs room-by-room control. Our estimate tool uses 500 sq ft per ductless indoor unit and prices up to 5 indoor units before a custom quote. Most installations take one day. Jobs with several ductless units can take two or three days.
Frederick in numbers
| Homes | Median year built | Built before 1960 | Built 2010 or later | Gas heat | Electric heat | Propane | |
|---|---|---|---|---|---|---|---|
| Frederick | 5,584 | 2007 | 3% | 39.8% | 88.4% | 10.8% | 0.1% |
| Weld County | 125,033 | 2000 | 12% | 24% | 73.9% | 17.1% | 6.7% |
| Colorado | 2,545,124 | 1987 | 16.3% | 14% | 66.7% | 25.2% | 4.9% |
| ZIP | Main town | Homes | Median year built | Heat with gas | Electric utility | Install area |
|---|---|---|---|---|---|---|
| 80504 | Firestone | 23,359 | 2003 | 82.3% | Longmont Power & Communications | Yes |
| 80516 | Erie | 13,163 | 2008 | 81.8% | Xcel Energy | Yes |
| 80530 | Frederick | 2,315 | 2005 | 85.2% | Xcel Energy | Yes |
Systems and rebates in Weld County
- Ducted heat pump in Weld CountyPrices by home age and the Weld rebates for this system.
- Dual-fuel heat pump in Weld CountyPrices by home age and the Weld rebates for this system.
- Ductless mini-split in Weld CountyPrices by home age and the Weld rebates for this system.
- Heat pump rebates in Weld County$7,000 on a 3-ton gas home, program by program.
- Pool heat pumps in Weld CountyPool and spa heat pumps: local code rules, running cost and the swim season.
Other towns we install in
Questions we hear
What heat pump suits a typical Frederick gas-heated home?
Utility gas heats 88.4% of Frederick homes. A ducted heat pump fits a home with usable ducts. Dual fuel fits a home that keeps its gas furnace for the coldest hours. For the 2,000 square foot, 2-story gas example built in 2010 or later, the design load is 2.0 tons. We measure the home, inspect ducts, and check the electrical panel before installation.
How are heat pumps sized in Frederick?
We size to 1°F outdoors and 70°F indoors. Our sizing uses 5,300 ft elevation, where an air-source unit loses 18% of output. The 2,000 square foot, 2-story gas example built in 2010 or later has a 2.0 tons design load. A comparable home built before 1960 has a 3.4 tons design load, showing why home age matters.
What rebates apply to a gas-heated Frederick home?
For the 2,000 square foot, 2-story gas example, total ducted rebates are $7,000. The programs are the Xcel Energy rebate ($4,500), the State of Colorado Heat Pump Discount ($1,000) and the Power Ahead Colorado rebate ($1,500). The State of Colorado Heat Pump Discount comes off the invoice. Power Ahead Colorado applies in Weld County. We file every rebate for the homeowner. The federal 25C credit ended for systems installed after 2025-12-31.
What does a ductless system cost for a Frederick home?
For a 1,500 square foot ductless example, our estimate tool uses 3 indoor units. The price before rebates is $11,800 to $19,200, and the price after rebates is $8,300 to $15,700. Ductless equipment fits homes without ducts, additions, and condos. It also fits Frederick's 10.8% share of homes heated with electricity.
How do the Frederick ZIP codes differ for heat pump planning?
In 80530, gas heats 85.2% of homes and detached houses account for 92.7%. In 80504, those figures are 82.3% and 75.2%. In 80516, they are 81.8% and 86.4%. Multiunit buildings account for 2.7% in 80530, compared with 14% in 80504 and 3.8% in 80516, making duct layout and building type important.